Codes / Whirlpool / Washer (front load)

Whirlpool F0 E2: Excessive suds were detected in the wash basket.

Whirlpool's page says F0 E2 means the washer detected excessive suds in the wash basket. The washer runs an automatic suds-reduction routine, and Whirlpool says to let it keep running.

Source: F0 E2 - Front Load Washer (Whirlpool Product Help), last updated by Whirlpool 2025-11-19; read 2026-10-17. 3 owner checks listed.

Fault isolation, in Whirlpool's order

• Owner check from Whirlpool's page
• Observation Whirlpool asks you to make
• Request service: technician only beyond here
• Code should clear

The checks, with Whirlpool's detail

1. 1Use only High Efficiency (HE) detergent

   Whirlpool says non-HE detergent or too much soap can cause excess suds, which may lower the spin speed, leave loads very wet and lengthen the cycle.

2. 2Read which light is on with the Sud or Sd display

   Whirlpool says that with the Rinse light on, the washer is removing suds, so let the cycle continue. With the Cycle Complete light on, the load may not be fully rinsed or drained, and it suggests selecting a Rinse/Spin cycle for extra rinsing.

3. 3Check the bulk dispenser, if the washer has one

   Whirlpool says to confirm whether the bulk dispenser is enabled, and if it is, not to add more detergent to the load. It also says to confirm the concentration level is set correctly, because an incorrect setting can cause extra suds.

4. Does F0 E2 still appear?

Same code, different meaning on other brands

None of the other brands in the verified set (Bosch, LG, Samsung, ) uses F0 E2 or F0E2 on the official pages read for this site. If your display shows F0 E2 on a different brand, do not apply these checks; use the lookup or that brand's own support page.

Same symptom on other brands

• SUDSamsung washer: Too many suds: the washer pauses, then continues on its own.
• SudLG washer: Too many suds were detected.
• SUDWhirlpool washer: Too many suds: the washer cannot spin the water out.

Other Whirlpool codes here

• F9 E1Whirlpool washer: Long drain time: the washer cannot drain correctly.
• F5 E2Whirlpool washer: The door is not locking properly.
• F0 E1Whirlpool washer: A load was detected inside during a Clean Washer cycle.
• F0 E5Whirlpool washer: Off balance: the load could not be balanced for spin.
• F21Whirlpool washer: A drain problem.
• F22Whirlpool washer: A front door lock issue.
• F5 E1Whirlpool washer: A door switch problem.
• F5 E3Whirlpool washer: The door is not locking properly.

That is 8 of the 18 Whirlpool washer codes verified here. The rest, with every display variant in one table, are on Whirlpool washer error codes.

Provenance